Dragon´s Lair dice tower castle ruins dice tower-dice roller-dragon dice tower

Dragon´s Lair dice tower Tower (Dice Tower)

roller tower with tray- DnD/Pathfinder/Tabletop RPG. You are purchasing a 3d printed dragon dice tower - dice roller tower with tray- DnD/Pathfinder/Tabletop RPG This item is made from grey PLA and is printed ready to dispatch/The grey dice tray pulls off and on from the the bottom of the dice tower   Dice Tower with tray- dice roller tower with tray- DnD/Pathfinder/Tabletop RPG Approximate size: piece 1 full dice tower (166mm long x 141mm wide x 147mm tall)  piece 2 dice tray 157mm x 155mm x 36mm dice tower only no dice tray/dice tower with tray available on my other listings thanks  dice tower will only work with d20 20mm dice and under so don't order if your dice are larger than 20mm thanks This listing is for an one dice tower and tray.Due to the nature of 3D printing, there will be print lines throughout the print, this is because FDM printers print in layer lines. There may be some bumps and blemishes that are not part of the original design.  However, sanding with sandpaper and/ or a sharp craft knife can typically get rid of most of these. On some occasions. Stringing (very thin strings of plastic) can also occur between points. I clean these up as much as I can. They can either be cut away or even melted (please take care not to heat the plastic up too much) away with a hairdryer. The underside of the prints may not be a smooth finish.