nuclear reactor dice Tower roller - dice tower-dice roller terrain piece

Dice Tower - dice roller tower with tray- DnD/Pathfinder/Tabletop RPG

Approximate size:

2 pieces together  full dice tower (138mm long x 111mm wide x 209mm tall)

This item is made in two part and can be glue together or left loose(figure and dice for scale only and not included in sale)

dice not included for scale only

This listing is for an one dice tower Due to the nature of 3D printing, there will be print lines throughout the print, this is because FDM printers print in layer lines. There may be some bumps and blemishes that are not part of the original design.  However, sanding with sandpaper and/ or a sharp craft knife can typically get rid of most of these. On some occasions. Stringing (very thin strings of plastic) can also occur between points. I clean these up as much as I can. They can either be cut away or even melted (please take care not to heat the plastic up too much) away with a hairdryer. The underside of the prints may not be a smooth finish.