Cheaper Than eBay
Cheaper Than eBay
Cheaper Than eBay
Cheaper Than eBay
Sliding Door Lock actuator FIX 4 Dodge Caravan Chrysler Town Country VW Routan
- Condition : New
- Dispatch : Next Day
- Brand : SRS
- ID# : 226847347
- Quantity : 1 item
- Views : 29
- Location : United States
- Seller : txjewelryman (+2565)
- Barcode : None
- Start : Wed 22 Jan 2025 17:44:03 (EDT)
- Close : Run Until Sold
- Remain : Run Until Sold
for 1 item(s)
Seller's Description
I BOUGHT THIS OFF TO FIX MY TOWN AND COUNTRY VAN
BUT SOLD THE VAN AND NEVER OPENED IT. IT IS STILL SEALED
THE INFO BELOW IS FROM THE ORIGINAL POST SELLER
IT WAS PAST RETURN TIME SO IM SELLING AT BELOW PRICE, ITS THE SAME ONE HE SELLS AS HE SOLD IT TOO ME!
BUY FOR CHEAPER PRICE
JUST TRYING TO GET SOME OF MY MONEY BACK!
Search youtube for
"Easy Fix Sliding Door Lock Dodge Caravan Chrysler Town Country 2008"
or here is the link: https://www.youtube.com/watch?v=xWtIe_xU160
If you can remove 1 screw, drill 2 holes in plastic, use zip ties, tighten 3 screws, cut wire and strip it 3/8" you can fix your sliding door lock.
Video shows how this is installed. Detailed wiring instructions included based on US 2013 model. With 9 months and nobody offering feedback on wiring differences all models must be the same. This fits 2008 and newer Chrysler Town and Country, Dodge Grand Caravans and the VW Routan.
Kit includes: lock actuator,T15 torx bit
The correct length rod and connector bracket
all zip ties
snap lever wire nut connector & color wiring instructions
Tools needed:..........
wire stripper
electrical tape
flat head screwdriver
drill hex adapter or screwdriver that uses hex head bits to use the included T15 bit
7/32" or 1/4" drill bit and drill
utility knife
pry bar
This will fix your power lock problem quickly. Most feedback has been about an hour start to finish.
Normal install of OEM part is between 3 and 8 hours of work,
This kit requires the manual lock to be working. If the actuator seized up and the lock cannot be moved try opening up the door panel and put some force on the linkage rod with a pliers or channel locks, same direction the manual lock would be pushing/pulling it while pushing the lock/unlock button. If you get it to move freely this kit will stop the overtravel where it jams on the original actuator by disconnecting that motor. These vans have some logic to not allow the power locks to be pressed 20+ times in a few minutes. It will eventually only flash the lights and not move the locks for a few minutes. Chrysler most likely programmed it like this 1) to not overheat the lock motors, 2) minimize warranty claims before 36,000 miles, 3) not drain the battery. I find it concerning that unlock won't attempt to move locks even after 10 seconds of no buttons pressed.
Original Failed Car part numbers:
4717960AC
4717961AB
68030378AF
68030380AD
746-259 72064
Listing Information
| Listing Type | Gallery Listing |
| Listing ID# | 226847347 |
| Start Time | Wed 22 Jan 2025 17:44:03 (EDT) |
| Close Time | Run Until Sold |
| Starting Bid | Fixed Price (no bidding) |
| Item Condition | New |
| Bids | 0 |
| Views | 29 |
| Dispatch Time | Next Day |
| Quantity | 1 |
| Location | United States |
| Auto Extend | No |
Seller Recent Feedback
Returns Policy
Returns Not Accepted
