sci-fi crashed spaceship basecamp wars legions/sci-fi outpost spaceship base 04

figure not included for scale purpose only

 as show on the photo images.Due to the nature of 3D printing there will be print lines throughout the print, this is because FDM printers print in layer lines. There may be some bumps and blemishes that are not part of the original design.  However some parts may need trimming with a hobbie knife and a bit of sanding with sandpaper and/ or a sharp craft knife can typically get rid of most of these. In some occasions . Stringing (very very thin strings of plastic)can also occur between points. I clean these up as much as I can. They can either be cut away or even melted (please take care not to heat the plastic up too much)away with a hairdryer. The underside of the prints may not be a smooth finish