|
This item is made from silver PLA and is printed ready to dispatch
Dice Tower - dice roller tower- DnD/Pathfinder/Tabletop RPG
This item is in one whole piece and is Approximate size:
piece 1 full dice tower (119mm long x 137mm wide x 123mm tall)
please note these mini dice tower are for D20 20mm dice and under and will not work with dice over 20mm
DICES AND FIGURE NOT INCLUDED FOR SCALE PURPOSE ONLY/ TOWER ONLY THANKS
This listing is for an one dice tower .Due to the nature of 3D printing, there will be print lines throughout the print, this is because FDM printers print in layer lines. There may be some bumps and blemishes that are not part of the original design. However, sanding with sandpaper and/ or a sharp craft knife can typically get rid of most of these. On some occasions. Stringing (very thin strings of plastic) can also occur between points. I clean these up as much as I can. They can either be cut away or even melted (please take care not to heat the plastic up too much) away with a hairdryer. The underside of the prints may not be a smooth finish.
|
for 1 item(s)
