FORD TRANSIT MK7 KEY OR BLUE 3 BUTTON REMOTE DIY PROGRAMMING (HIRE THE KIT)
- Condition : Used
- Dispatch : Next Day
- Brand : None
- ID# : 230594741
- Quantity : 1 item
- Views : 6
- Location : United Kingdom
- Seller : trolleycoins (+2144)
- Barcode : None
- Start : Fri 04 Jul 2025 22:53:14 (BST)
- Close : Run Until Sold
- Remain : Run Until Sold
for 1 item(s)
editShipping Calculator
Seller's Description
The Transit MK7 OBD port can be found under steering columb. Simply pull the panel to release the
clips and access the port :
MODE 1— CHECK NUMBER OF PROGRAMMED KEYS
1. With ANY key, turn your ignition to position II. At this point your dash should
be lit.
2. Plug the tool in to the vehicles OBD connector with all DIP switches set to
OFF.
3. The LED on the tool will light up RED/GREEN/BLUE and you will hear 3 as-
cending tones to indicate it is powered.
4. After approximately 2 seconds, the LED on the tool will flash ORANGE as it
sends the commands. It will then flash GREEN and beep a number of times
corresponding to the number of keys currently programmed to the vehicle.
The tool will flash/beep 5 times if there are no keys programmed.
5. The tool will then light up again RED/GREEN/BLUE and you will hear 3 de-
scending tones to indicate the process has finished.
MODE 2 — ADD KEYS
1. Turn your ignition key to position II WITH THE KEY YOU WISH TO ADD. At this point
your dash should be lit.
2. Plug the tool in to the vehicles OBD connector with DIP switch 4 ON.
3. The LED on the tool will light up RED/GREEN/BLUE and you will hear 3 ascending
tones to indicate it is powered.
4. You will then hear another high beep and see a BLUE flash. At this point the tool is in
‘add key mode’.
5. The LED on the tool will flash ORANGE as it sends commands to the vehicle. After
approximately 5 seconds, the LED on the tool will flash GREEN and beep a number of
times corresponding to the number of keys currently programmed to the vehicle. If
the procedure has succeeded, this number will be +1 to the number of currently pro-
grammed keys.
6. The tool will then light up RED/GREEN/BLUE and you will hear 3 descending tones to
indicate the process has finished.
MODE 3 — DELETE KEYS
1. Turn your ignition key to position II WITH ANY KEY. At this point your dash should be
lit.
2. Plug the tool in to the vehicles OBD connector with DIP switch 3 ON.
3. The LED on the tool will light up RED/GREEN/BLUE and you will hear 3 ascending
tones to indicate it is powered.
4. You will then hear another two high beeps and see two BLUE flashes. At this point the
tool is in ‘delete key mode’.
5. The LED on the tool will flash ORANGE as it sends commands to the vehicle. After
approximately 5 seconds, the LED on the tool will flash GREEN and beep five times to
indicate there are zero keys programmed.
6. The tool will then light up RED/GREEN/BLUE and you will hear 3 descending tones to
indicate the process has finished
Listing Information
| Listing Type | Gallery Listing |
| Listing ID# | 230594741 |
| Start Time | Fri 04 Jul 2025 22:53:14 (BST) |
| Close Time | Run Until Sold |
| Starting Bid | Fixed Price (no bidding) |
| Item Condition | Used |
| Bids | 0 |
| Views | 6 |
| Dispatch Time | Next Day |
| Quantity | 1 |
| Location | United Kingdom |
| Auto Extend | No |
