Church Ruin - chapel ruins set for Wargaming Terrain Scenery Gothic Building

***Please note that this piece comes UNPAINTED and it's in 1 piece

You are purchasing an unpainted ruin church terrain piece for wargaming.(32mm figures not included are for scale purposes only)

This item is made from  dark Grey PLA and is printed ready to dispatch

This building comes as one Part

Approximate size:

225mm long x 68mm wide x 92mm tall

This listing is for an unpainted church ruin as show on the photo images.Due to the nature of 3D printing there will be print lines throughout the print, this is because FDM printers print in layer lines. There may be some bumps and blemishes that are not part of the original design.  However sanding with sandpaper and/ or a sharp craft knife can typically get rid of most of these. In some occasions . Stringing (very very thin strings of plastic)can also occur between points. I clean these up as much as I can. They can either be cut away or even melted (please take care not to heat the plastic up too much)away with a hairdryer. The underside of the prints may not be a smooth finish.

Painting tutorials for various terrain pieces can be found on YouTube