Triumph 1960-62 Pre-unit 650 Duplex Engine- Frame Mounting Studs Fixings 6T T120

"TRI-REST" MANUFACTURED PRODUCT;

TRIUMPH PRE-UNIT 1960 - 1962 ENGINE PLATE TO FRAME SET.

For 650cc duplex frame models - 6T, T110, T120 and TR6.    

Bright zinc plated.

Here is a complete set of new studs - bolts - nuts and washers for fitting the engine/engine plates to the DUPLEX frame models.

The set consists of (60-pieces) all sized and bright zinc plated. They are a replica of originals as were used on all 650cc pre-unit 1960 to 1962 models; 6T Thunderbird, Tiger T110, Bonneville T120 and Trophy TR6.

The set includes the bolt / washer for the top rear crankcase & mouth screws for inside boss (not shown) for assembling the crankcase before fitting to frame. The stud / nuts / washers for assembling the main frame to the rear sub-frame at the top of the seat down tube is also included (not shown).

Will not fit rigid frame models. Will not fit earlier than 1960 models.

I currently stock seven engine mounting sets for pre-unit Triumphs;

3H, 3HW, T70, T80 models – search item no. 294871720285

1946-51 350cc 3T rigid frame model - search item no. 304390305272

1948-53 TR5 rigid frame model - search item no. 294924958508

1938-54 500cc & 650cc rigid frame models - search item no. 294854827406

1954-59 500cc & 650cc swinging-arm models - search item no. 294876772387

1960-62 650cc duplex frame models - search item no. 294925308985

TRW 500cc rigid frame model - search item no. 294881139398