Statue of the Fallen Goddess wargame broken statue figure wargame terrain piece

You are purchasing a 3d printed 

Statue of the Fallen Goddess wargame broken statue figure wargame terrain piece  

This item is made from grey PLA and is printed ready to dispatch and is unpainted

This item  is in 1 whole  piece.

Approximate size:

statue size is 122mm long x 119mm wide x 105mm tall)

Due to the nature of 3D printing, there will be print lines throughout the print, this is because FDM printers print in layer lines. There may be some bumps and blemishes that are not part of the original design.  However, sanding with sandpaper and/ or a sharp craft knife can typically get rid of most of these. On some occasions. Stringing (very thin strings of plastic) can also occur between points. I clean these up as much as I can. They can either be cut away or even melted (please take care not to heat the plastic up too much) away with a hairdryer. The underside of the prints may not be a smooth finish. 

Pictures are the actual printed model that you will receive, if there is a painted version shown it is for illustration only. 

 As this model is 3d printed parts will have  faint layer lines