XADO EX120 MOTO GEL REVITALIZANT FOR MOTORCYCLES AND SMALL ENGINES

Bid Now and Save Money!!!

How usual occurs wear?

Here is schematic picture of defect of friction plain. In this case it is scratch along axes of surfaces moving.

Look: selected zone is zone of anomalous surface activity.

XADO technology restores the surface of machines and engines by uses energy of friction and makes rebonding by creating cermet layer. XADO revitalizants contain building material for future surface and unique energetic activator which allows transfer redundant friction energy into creation of new crystal lattice – new surface.

How it happens:

Revitalization starts in overloaded zone (zone of maximal wear), because here is enough energy to start a new process and metal atoms have biggest amount of free (noncompensated) bonds.

This bonds, like a magnets, catch and attract building material right into zones of maximal wear. Energetic activator directs redundant energy on building of new crystal lattice. Thereby new covering appears on old surface.

In a few minutes after revitalization start on wear place appears cermet (metal and ceramic) patch. Zone of anomalous activity vanishes. Energetic processes stop and growing of surfaces stops. In the same time happens diffusion of metal and cermet. Diffusion ends process of forming new surface, and destroy defect by cementing.

How regulates surface growing?

If we look on every detail through microscope, we will see, that even the smoothest surface seems uneven. It looks like chain of peaks and hollows.  Step by step metal atoms from “week places” being knocked out by wear and become chipping. Hollows deeps more and more.  Some people thinks, that 100% wear becomes when whole detail becomes into dust, but it is mistake. Total wear happens when peaks become obliterated.  But until this peaks exist there is a possibility to restore detail by revitalization. Because this peaks “remember” primary sizes of detail. By the way, from this follows that detail never will be more than primary size, because when hollow comes abreast with peak, conditions for revitalization disappears. Building material which wasn’t used is ready for building in any time when will appear zone of anomalous activity (wear).

The compound is designed for protection of engine parts against wear and restoring repair of gasoline engines without disassembling. Revitalizant fits any tipes of motor oil doesn't enter into a chemical reaction with them and doesn't  change theit viscosity. The gel forms a new cermet coating on friction surfaces (the parts grow in volume, restore their original geometry). As a result a renovated unit exceeds the performance level of a new one and will serve you 2-4 times longer.

Advantages of XADO Revitalizant:

Restores worn surface of engine cylinders, eliminates microcracks and scratches

Increases and levels compression in cylinders

Protects friction surfaces against wear

Reduces fuel consumption considerably

Restores engine capacity up to factory values

Increases service life of an engine by 3 times

Decreases the level of toxic components in exhaust gases

Decreases noise and vibration level

Application instructions