Triumph TR5 Pre-unit 1948-53 Rigid, Engine Plate to Frame Mounting Studs Fixings

TRIUMPH ENGINE/ENGINE PLATE TO FRAME SET,

TR5 500cc - Rigid frame models only.

Bright zinc plated.

Here is a  set of engine mounting studs for the TR5 TROPHY 1948 to 1953 Pre-unit Rigid frame model. Will fit all TR5 models with a rigid frame, so if your model is 1954 and has a rigid frame, then this will fit. New studs, nuts and washers.

Please note that the special sleeve nuts (82-3004) are not included, which are used on the front engine plate on one of the lower studs.  Instead, standard 3/8" full nuts are provided. This does mean that this set is not authentic for the model, but this set is an alternative that mounts the engine plates. This set also DOES NOT include the four spacers. These are sometimes welded to the rear engine plates. Includes 14 studs (one is missing from the photo).  

The large main stud (0994) that holds the main frame to the rear sub-frame is also included in the set with the nuts and washers. 

All of the parts are sized as originals and are bright zinc plated. 

Will not fit swinging-arm models, or any other rigid frame model other than TR5.

I currently stock six engine mounting sets for pre-unit Triumphs;

3H, 3HW, T70, T80 models – search item no. 294871720285

1948-53 TR5 rigid frame model - search item no. 294924958508

1938-54 500cc & 650cc rigid frame models - search item no. 294854827406

1954-59 500cc & 650cc swinging-arm models - search item no. 294876772387

1960-62 650cc duplex frame models - search item no. 294925308985

TRW 500cc rigid frame model - search item no. 294881139398