"TRI-REST" MANUFACTURED PRODUCT;
TRIUMPH PRE-UNIT 1938 - 1954 ENGINE PLATE TO FRAME SET.
500cc and 650cc Rigid frame models ONLY - 5T - T100 - 6T
Bright zinc plated.
Here is a complete set of new fixings; studs, bolts, nuts and washers. For fitting the engine/engine plates to the RIGID frame models. The set consists of (68-pieces) all sized and bright zinc plated. A replica of originals as were used on all 500cc and 650cc pre-unit rigid frame models; 5T SpeedTwin, Tiger T100, 6T Thunderbird, from 1938 to 1953/4.
The set includes the bolt / washer for the top rear crankcase and mouth screws for inside boss (not shown) for assembling the crankcase before fitting to frame.
The stud / nuts / washers for assembling the main frame to the rear sub-frame at the top of the seat down tube is also included (82-1561).
Also includes the bottom frame stud / nuts / washers (82-0994).
Will not fit swinging-arm models. Will not fit 1954+ models. Not suitable for TR5 Trophy. But I do stock sets for these models, see below;
I currently stock seven engine mounting sets for pre-unit Triumphs;
3H, 3HW, T70, T80 models – search item no. 294871720285
1946-51 350cc 3T rigid frame model - search item no. 304390305272
1948-53 TR5 rigid frame model - search item no. 295635117645
1938-54 500cc & 650cc rigid frame models - search item no. 294854827406
1954-59 500cc & 650cc swinging-arm models - search item no. 294876772387
1960-62 650cc duplex frame models - search item no. 294925308985
TRW 500cc rigid frame model - search item no. 294881139398
Check out Nooky's Nuts shop for other Tri-Rest manufactured parts - exclusively available at Nookys Nuts.
for 1 item(s) edit
