Preformed Shower Pan - ready for tile 32 x 32

PREFORMED SHOWER PAN

32" x 32" Square

in stock - Ships same Day

Don't be fooled by cheap imitations. We are the original preformed shower pans.

The curbs are placed on the 2nd listed dimension above

Curb sizes: front high 5 3/8" - inside curb high 2" - top curb 3 3/8"

PVC or ABS Drain

Use any thin-set setting material for installation

35 year Warranty

DESCRIPTION;

The Fin Pan PreFormed Shower Pan is a Ready to Tile, waterproof shower pan that can be installed in minutes, which reduces the time and labor involved with the old mud bed methods.

No need to build a frame just set it in place and you are ready for your tile installation.

Includes Square shower drain - screw-less.

Heavy duty Solid unit - not hollow parts

It is lightweight and has a built-in drain connection, so it's ultra-easy to handle and install.

The material used to construct the Fin Pan PreFormed Shower Pan is 100% waterproof, and is rot resistant.

FEATURES:

- Waterproof and rot resistant

- Light weight, easy to handle and install

- Time and labor savings

- Can be installed and tiled in the same day

- Drain assembly and curb included

- No special training necessary

- Custom sizes can be ordered

- Sloped per industry standards

Materials: Latex modified thin-set, 1/2" x 1/2" square notched trowel for installing pan. PVC or ABS solvent for drain connection. Polyurethane sealant for sealing joint between pan and walls.

PREPATORY WORK

1 Plug the inside of the drainpipe and fill the pan with water for 24 hours. Note: Shower pans are 100% waterproof from the factory. It is the user’s responsibility to ensure waterproof integrity is still intact after shipping. 2 Ensure that walls are square and plumb for proper fit of pan. 3 Sub floor under pan must be clean and level. Cut floor drainpipe 5/8" above the sub floor. 4 Remove square strainer from the drain and test fit pan to make certain it fits over drainpipe properly and sits flush and level with floor. 5 Remove the pan.

INSTALLATION

1 Apply a medium bed, latex modified thin-set to the floor area and the underside of pan. Use a 1/2" x 1/2" square notched trowel. 2 Apply a liberal coat of PVC or ABS cleaner and then solvent cement to the drainpipe and inside the drain where the connection will be made. Note: Solvent choice based on drain type. Follow manufacturer’s instructions. 3 Set pan into the wet thin-set and apply pressure to achieve complete coverage. 4 Apply 1/2" backer board to the walls coming flush with the top of pan walls. 5 Seal joint between backer board and pan using WaterArmor Liquid Waterproofing and fiberglass mesh or Polyurethane sealant. 6 Screw square strainer down to correct height to match tile. Pack thin-set or pea gravel into area cut out for strainer adjustment. 7 Install tile according to Tile Council of North America (TCNA) guidelines.

for more info contact us at

Click here for more information