APPION, Refrigerant Recovery Pre-Filter KIT , MADE FOR ALL THE APPION UNITS.

****SPECIALLY MADE FOR THE  APPION REFRIGERANT RECOVERY UNITS

All items pictured are shipped loose.

The picture shows an assembled kit.

We don't know how you want it configured so the items are shipped loose in order to allow for configuration on your application.

Not only will this protect your recovery unit from damage, it will make it easier for you to connect the hose to the pre-filter because of the special "swivel-elbow"  fitting.

A must actually for all recovery units with a "pointing down" inlet fitting!

(1) 4050, ES Pre-Filter, Male x Female flare (BI-Dirrectional) (4) Spare gaskets.

(1) 19201, Yellow Jacket 1/4" QuickCoupler 90 degree with valve core depressor.

(1) 1/4" Copper Flare Seal that goes on the female side of the pre-filter.

In the future you need only purchase the filter so the savings are great!

Refrigerant Recovery Pre-Filter KIT

WILL WORK ON ALL THE APPION refrigerant RECOVERY UNITS.

AND THE FOLLOWING REFRIGERANTS;

R12, R12a, R134a, R22, R22a, R404a, R410a, R502,

ALL HFC,s

ALL CFC's

ALL BLENDS, including R410a.

If you own a refrigerant  recovery/recycle  unit then you know how important it is to take care of it.

Most of the damage that occurs to recovery units is from foreign material entering the recovery unit and damaging the compressor.

If your recovery unit has a ""OIL-LESS" compressor, it is even more critical that you prevent foreign material from entering the unit.

Now comes the dilemma that some recovery owners face.......there is simply not enough room to screw on a pre-filter and then your hose, or you have to use a expensive male x female pre-filter.

This kit takes care of both of those problems.

Protect your expensive piece of recovery equipment with this inexpensive kit!!