Spirax Sarco KC43 Steel self acting control valve DN40 PN40 Flanged

Picture describes, ex mod stores  this is new and unused but  we have no seperate paper work  or certification.

priced accordingly.

#Mfr spec for information;

Description The KA, KB and KC range of two-port valves are used in conjunction with Spirax Sarco SA control systems to provide a self-acting temperature control unit. Available types KA43 Normally open with flanged connections. KB43 Normally open with phosphor bronze pressure balancing bellows with flanged connections. KC43 Normally open with stainless steel pressure balancing bellows with flanged connections. Note: Pressure balancing bellows enables the valve to operate against higher differential pressures. Standards These products fully comply with the requirements of the Pressure Equipment Directive (PED) and carry the mark when so required. Certification As standard these products are available with a manufacturers’ Typical Test Report. Additionally, at extra cost, certification to EN 10204 3.1 can be supplied. Note: All certification / inspection requirements must be stated at the time of order placement. Size and pipe connections KA43 KB43 KC43 DN15, DN20, DN25, DN32, DN40 and DN50 DN25, DN32, DN40 and DN50 DN32, DN40 and DN50 Standard flanges: EN 1092 PN25 and EN 1092 PN40, ASME 300 and BS 10 Table H. The following flanges are available on request: ASME 150. KA43, KB43 and KC43 Steel Self-acting Control Valves TI-P078-06 CTLS Issue 8 KA43 KB43 and KC43 TI-P078-06 CTLS Issue 8 Page 2 of 5 KA43, KB43 and KC43 Steel Self-acting Control Valves The product must not be used in this region. A - B Flanged EN 1092 PN40, ASME 300 and BS 10 Table H. A - C Flanged EN 1092 PN25 and ASME 150 Body design conditions PN40 Maximum design pressure 40 bar g @ 20 °C Maximum design temperature 300 ° bar g Minimum design temperature -10 °C Maximum operating temperature A - B 300 ° bar g A - C 300 ° bar g Minimum operating temperature Note: For lower operating temperatures consult Spirax Sarco 0 °C Maximum differential pressure bar Size DN15 DN20 DN25 DN32 DN40 DN50 KA43 17.0 10.0 4.5 3.0 2.0 1.5 KB43 - - 10.0 9.0 8.2 6.9 KC43 - - - 16.0 16.0 13.8 Designed for a maximum cold hydraulic test pressure of: 24 bar g Kv values Size DN15 DN20 DN25 DN32 DN40 DN50 For conversion: Cv (UK) = Kv x 0.963 Cv (US) = Kv x 1.156 KA43 2.90 4.64 9.80 16.48 23.70 34.00 KB43 - - 9.80 16.48 23.70 34.00 KC43 - - - 16.48 16.48 34.00