Statue of the Gods dice Tower roller god statue - dice tower-dice roller

This item is made from grey PLA and is printed ready to dispatch/The grey dice tray pulls off and on from the the bottom of the dice tower 

Dice Tower with tray- dice roller tower with tray- DnD/Pathfinder/Tabletop RPG

Approximate size:

piece 1 full dice tower (161mm long x 119mm wide x 185mm tall)

This listing is for an one dice tower and tray.Due to the nature of 3D printing, there will be print lines throughout the print, this is because FDM printers print in layer lines. There may be some bumps and blemishes that are not part of the original design.  However, sanding with sandpaper and/ or a sharp craft knife can typically get rid of most of these. On some occasions. Stringing (very thin strings of plastic) can also occur between points. I clean these up as much as I can. They can either be cut away or even melted (please take care not to heat the plastic up too much) away with a hairdryer. The underside of the prints may not be a smooth finish.