set of 5 Church Ruin ruins pieces for Wargaming Terrain Scenery Gothic Building

***Please note that these pieces are a five-piece set and come unpainted

You are purchasing an unpainted ruin church terrain piece for wargaming. (32mm figures, trees and board are not included are for scale purposes only)

This item is made from dark Grey PLA and is printed ready to dispatch

This set is 5 separate pieces of a church/chapel ruins

Approximate size:

piece 1 (42mm long x 67mm wide x 92mm tall)

piece 2 (95mm long x 52mm wide x 75mm tall)

piece 3 (106mm long x 42mm wide x 85mm tall)

piece 4 (101mm long x 70mm wide x 97mm tall)

piece 5 (100mm long x 40mm wide x 85mm tall)

This listing is for an unpainted church / chapel ruin. Due to the nature of 3D printing, there will be print lines throughout the print, this is because FDM printers print in layer lines. There may be some bumps and blemishes that are not part of the original design.  However, sanding with sandpaper and/ or a sharp craft knife can typically get rid of most of these. On some occasions. Stringing (very thin strings of plastic) can also occur between points. I clean these up as much as I can. They can either be cut away or even melted (please take care not to heat the plastic up too much) away with a hairdryer. The underside of the prints may not be a smooth finish.

Painting tutorials for various terrain pieces can be found on YouTube