Fiat Panda II (169) 04-12 USB Smart Charger with socket extension

Description

Obviously it will fit any car with cigarette socket, but this charger is specially suitable for Fiat Panda II (169) due to cigarette socket location. I found that wires lining flat to the back of the passenger seat do not interfere with my hand while using hand brake or adjusting mirrors by switch buttons.

Two expansion pins on the side of the charger are very sturdy. I advise to hold down cigarette socket plastic in Panda while removing this charger, otherwise you can take it out with whole socket, but positive fact is that --> finally no problem with self disconnecting charger from the socket.

Little display will show you car battery charging/voltage. Not just charger voltage like in many, but real car charging system voltage. Blue = OK (11.6V-14.8V) while Red = low charging or overcharging (less than 11.6V or more than 14.8V). Please look at the photos/video.

It shows real current "A" consumption on display, real Voltage charging mode (5V normal charge, 9V reasonable fast charge, 12V real fast charge). Smart charger - self adapting safe mode for connected device.

Smart charger - you will notice different current flow "A" at different charging stages, everything depends of your connected phone/device, but basically:
- battery discharged/very low 0-20%: soft wake up charge of 1.2-1.8A
- low/mid battery state 20-50%: smart fast charge of 1.9-3.1A
- high battery state 50-80%: smart fast charge of 1.6-2.1A
- nearly fully charged battery state 80-100%: trickle charge of 1.0-1.5A


I like quality, that's why real photos in here, please look at the photo with pictured socket extension --> sort of brass pin inside indicate sort of quality there rather than basic stuff.

12V/24V so can be used on HGV/PSV

Safety:
short circuit/overvoltage/overcurrent protection chip
over temperature protection chip
anti-interference protection chip


It's reasonable "fast charger". It's not extremely "fast", but reasonable "fast", so far tests done:
Huawei Y 2019: charger adapted mode: 5V/1.8A: makes phone charging fast as genuine wall charger.
Huawei Mate 20 Pro: charger adapted mode: 9V/1A: phone doesn't show "fast charging" mode, BUT after few seconds phone shows additional lightning sign which is indication for sort of "faster" charging, but not the fastest possible mode for this phone model.

Order processing