This item is made from grey PLA and is printed ready to dispatch/The grey dice tray slides on and off the the bottom of the dice tower sand castle mini dice roller tower with tray- dice roller tower with tray- DnD/Pathfinder/Tabletop RPG Approximate size: full tower L 70mm x W 71mm x H114mm piece 1 castle top dice tower (70 mm long x 70 mm wide x 83mm tall) piece 2 castle top dice tower (64 mm long x 67 mm wide x 31mm tall) + 3 pegs piece 3 removable dice tray (117mm long x 81mm wide x 25mm tall) this dice tower fits together very easily just put a bit of glue on the pegs in the holes and fit the two parts together dice not included for scale only This listing is for an one dice tower and tray.Due to the nature of 3D printing, there will be print lines throughout the print, this is because FDM printers print in layer lines. There may be some bumps and blemishes that are not part of the original design. However, sanding with sandpaper and/ or a sharp craft knife can typically get rid of most of these. On some occasions. Stringing (very thin strings of plastic) can also occur between points. I clean these up as much as I can. They can either be cut away or even melted (please take care not to heat the plastic up too much) away with a hairdryer. The underside of the prints may not be a smooth finish. | 
for 1 item(s) edit
