wizards castle dice tower / castle dice tower/castle dice tower shaker/ DnD/RPG

This item is made from grey PLA and is printed ready to dispatch.

This dice tower comes in two pieces no assemble needed dice tray pops on and off easy/can be used with or without dice tray

Approximate size:

piece 1 full dice tower (81mm long x 81mm wide x 192mm tall)

piece dice tray (96mm long x 140mm wide x 29mm tall)

please note these dice towers are for D20 20mm dice and under and will not work with dice over 20mm

Dice and figures not included for scale purposes only

This listing is for an one dice tower and tray.Due to the nature of 3D printing, there will be print lines throughout the print, this is because FDM printers print in layer lines. There may be some bumps and blemishes that are not part of the original design.  However, sanding with sandpaper and/ or a sharp craft knife can typically get rid of most of these. On some occasions. Stringing (very thin strings of plastic) can also occur between points. I clean these up as much as I can. They can either be cut away or even melted (please take care not to heat the plastic up too much) away with a hairdryer. The underside of the prints may not be a smooth finish.