portal dice tower/ tree portal dice tower/tree/tree portal/forest portal DnD/RPG

This item is made from grey PLA and is printed ready to dispatch.

This dice tower takes two dices at the same time if you wish as it has two inlet holes on the top left/right of the portal

there are also two exit holes at the bottom of the portal one on the back and one on the front so you and a friend can use it together without having to turn it around in between goes

This portal dice tower comes in one whole pieces no assemble needed

Approximate size:

piece 1 full dice tower (175mm long x 137mm wide x 172mm tall)

please note these dice towers are for D20 20mm dice and under and will not work with dice over 20mm

This listing is for an one dice tower and tray.Due to the nature of 3D printing, there will be print lines throughout the print, this is because FDM printers print in layer lines. There may be some bumps and blemishes that are not part of the original design.  However, sanding with sandpaper and/ or a sharp craft knife can typically get rid of most of these. On some occasions. Stringing (very thin strings of plastic) can also occur between points. I clean these up as much as I can. They can either be cut away or even melted (please take care not to heat the plastic up too much) away with a hairdryer. The underside of the prints may not be a smooth finish.