Clear Glossy Vehicle Protection Film Sheet Stone Chipping Protection Layer Cover

Important Info About This Item:

Item comes with its own peel-off backing so no need to purchasing additional adhesive sprays.

Vinyl thickness varies between 60 - 90 microns

Non of these products are anything other than Water-based adhesive

The following info applies to Vinyl

- These materials are suitable to be applied on to any smooth, flat surface, regardless what it may be. It is NOT suitable to be used as a wrap and cannot be applied over raised areas or grooves as this will result in creasing.

- suitable for vehicle wrap

Bubbles are common when applying any type of self adhesive vinyl so we always recommend using the wet method to apply and always use a squeegee to apply and push out the air bubbles

Application Instructions:

Step 1. Preparation

1. Make up the slip solution in spray bottle (1 tsp washing up liquid to 1 pint cold water)

2. Thoroughly wash the smooth, flat surface with slip solution & squeegee dry.

3. (if applicable) Remove paint, varnish or other foreign matter with a scraper.

4. Spray surface with slip solution & squeegee out, checking that the surface is very clean & dust free

Step 2. Film Handling

1. Adhesive surface is protected between ‘vinyl film’ and liner

2. The vinyl may be cut to approximate size with a very sharp blade. It is recommended that the film be cut at least 1/2” longer & wider than the surface area if you plan on covering the whole thing. You are now ready to apply the film.

Note: Separate a corner of the ‘vinyl’ and liner with 2 small pieces of adhesive tape on either side of the product.

Step 3. Film Application

1. Thoroughly wet the surface you re about to cover with the slip solution, this will hold the film in place whilst you remove the clear liner.

2. Place film on the area with liner facing you. From the ready separated corner carefully peel

off the liner. Spray the adhesive surface generously with the slip solution ( you cannot apply too

much solution)

3. Carefully reverse film on to the area you are covering so that the adhesive side is now in contact with the surface.

Note: Keep film straight, do not allow film to curl up on itself or to wrinkle. A crease or wrinkle will not flatten out on application.

4. Position the film by gently sliding on wet surface and smoothing out large air bubbles.

Ensure all surface area is covered by the film

Step 4. Squeegee Technique

1. Spray the film with the slip solution to give slip for the squeegee.

2. The first stroke should be horizontal across the top of the surface.

3. The next stroke should be downwards from one edge with succeeding strokes working down and away from the first strokes.

4. On final squeegee of the top & bottom edges the squeegee may be pushed towards the edges to remove any excess water.